You are here: Home / Installation

Installation

Installation, use and maintenance instructions

 

Previous note


The cartridge containing the rollaway sheet of our screens is delivered already placed in the widest of the two vertical profiles of the frame (see installation video to appreciate it clearly). This profile can be placed both on the left side and on the right side. And, once fixed, thanks to its powerful adhesives, you cannot separate it from the wall without damage it; therefore you must decide on which side you are going to fix the vertical profile before doing so.

Installation

1

Clean and dry the walls for an optimal adherence. Remove the adhesive protection from the vertical profile that supports the rollaway cartridge and fix it to the wall.

1

2

Place the vertical closing profile as shown in the image of the circle, with the L-shaped part facing outwards.

2

3

Remove the protection from the vertical closing profile and fix the latter on the wall.

3

 

4

Spread out the guide rails until they are inserted into their brackets.

 

4

5

Insert the guide rail into the corresponding bracket at the same time as the wheel.

5

6

Use a 2,5 mm Allen key to tighten the screws that hold the guide rails, with little pressure, to avoid deformations in the aluminium.

6

Use

To close

To open

Important notes

  • A) FOR SHOWER TRAYS WITH PERIMETER RIMS: For a shower tray that has a perimeter flange or skirt higher than the sink, the screen will be installed on top of it. Once installed it is not necessary to seal the lower guide at all.
  • B) FOR COMPLETELY FLAT SHOWER PLATES WITHOUT PERIMETER RIMS: Seal the outer perimeter of the shower tray with silicone anti-mold, between the aluminum bottom guide and the shower tray.

 

Maintenance

  • The screen incorporates a self-cleaning system in the roll-up box, and does not require manual cleaning.
  • For general maintenance, use soap or mild detergent.

 

 

Download PDF

See installation video